Poor signal or performance issues? Your wireless card may be connecting to the ‘wrong’ access point.

by Eric Geier

When you connect to a wireless network, you are connecting to a single access point (AP) — though the radio card (aka client card, network interface card, or NIC) in your laptop will roam to other APs with the same SSID (or network name), which allows mobile users to move about a facility and continue to use the network. However, not all client radios use the exact same reasoning and techniques to deal with roaming, and radio frequency (RF) interference and other environment conditions can cause problems.

If your wireless network is outfitted with multiple APs, and users experience poor signal strength and performance despite proper coverage in the area, the user’s radio card may not be connecting to the closest or most ideal access point for that specific location.

Here are a few symptoms of a client connecting to the wrong AP:

  • Low signal strength
  • Poor performance
  • Intermittent connectivity

Verifying the Problem

Since these symptoms are similar to other network issues, you should try to verify that the radio client is connecting to the wrong AP, and not just sitting too far away from the right one.

What’s That Term?

Not sure what a particular term means? Check out the searchable PracticallyNetworked Glossary.

One way to verify this problem is to find where the nearest APs are located in relation to the location of the problem client, using a facility map of the AP locations. Check to see which AP the client is connected to when problems occur. This can be done by checking the association lists on the APs, or by using a Wi-Fi analyzer. Then check if there’s a closer or more ideal AP for the client, keeping in mind the environment of the facility.

For example, say you checked your AP association lists and saw that the client is connected to AP 2, which is located on the next floor down. However, the facility map indicates that AP 1 is slightly closer to the client and doesn’t have any obstructions in the way. Therefore, you can conclude that the radio is likely connecting to the wrong AP.

Quick Fixes

Here are a few things to try in order to temporarily fix the problem:

  • Restart the radio card. Simply disabling and re-enabling the radio card may work. During initial scanning, the client may choose the correct AP.
  • For mobile clients, move around. Moving the client around may make the radio card realize there’s a better AP in range.
  • Use MAC address filtering. You could block the client from connecting to “incorrect” AP(s) by only allowing clients with specific MAC addresses.
  • Change AP transmit power. You could slightly decrease the transmit power on “incorrect” AP(s) or slightly increase the transmit power on “correct” AP(s).

Fixing the Underlying Problem

Although you may be able to find a temporary fix for this problem, you may want to do some in-depth analysis of the network and RF conditions. For example, check to see if occasional RF interference causes the problem, and analyze AP placement. You should also keep in mind that the underlying cause of the problem may be the client card’s scanning methods and techniques; therefore, you could try replacing the card, or see if there’s a driver update that may fix the issue. You may also want to contact the manufacturer to report the issues you’ve found.

Eric Geier is the founder and president of Sky-Nets, Ltd., which operates a Wi-Fi hotspot network serving the general aviation community. He has also been a computing and wireless networking author and consultant for several years. Eric’s latest book is Wi-Fi Hotspots: Setting up Public Wireless Internet Accesspublished by Cisco Press.

Article originally published on WiFiPlanet.com.